Footblock Replacement Instructions: All Current CMC Models

Replace the Footblock

Replace the Footblock
IMPORTANT: Make sure the Driver Pack/ECU is turned off and the FrameShop software is closed.
Move the Head and the Gantry to the far right of the cutting board. Remove the Blade Cartridge.	Move the Head and the Gantry to the Far Right of the Board

CMC Z1/Z (9000z)/9000/8500e SBT:

CMC Z1/Z (9000z)/9000/8500e SBT:
Loosen the three 1/8” Allen set screws holding the Footblock to the Head assembly motor shaft. There is one screw on the top.	Loosen the Three Allen Set Screws Holding the Footblock to the Head

CMC 8500e/8500/8000:

Testing the Footblock: All Models

Testing the Footblock: All Models

Knowledge Base