Check out our new How To section at: How To...

Bump on the Circle/Oval Rotation Utility

Owned by dani.simmonds
Last updated: Aug 22, 2024
2 min read

Bump on the Circle/Oval Rotation Utility

Bump on the Circle/Oval Rotation Utility

  • The Circle/Oval Rotation Utility is a more detailed calibration feature than adjusting the Oval Rotation field alone because it allows for adjustments for different sizes of ovals.

  • This is like adjusting the Oval Rotation field on the Configurations screen, but is specific to this particular oval size.

  • If the Oval Opening has a Bump, Increase the Oval Rotation by moving the slider to the right.

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

If the Oval Opening has a Bump, Increase the Oval Rotation.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

Bump in the Oval Opening
Oval Rotation for Oval Openings

See: Oval Rotation Configurations

See: Oval Rotation for Openings Configurations

See: Oval Rotation for Drops Configurations

See: Oval Rotation for the Outside Configurations

See: Outside Oval Rotation for V-Grooves Configurations

See: Inside Oval Rotation for V-Grooves Configurations

Â