Tool Line Too Long
Tool Line Too Long | |
---|---|
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool. If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot. This is similar to the Overcut used with the Blade cartridges. The Overshoot Controls How Far Past the Segment to Apply the Tool Overshoot Field When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OKÂ and do another test cut. Continue making adjustments until the desired outcome is achieved. |