Check out our new How To section at: How To...

Move Origin Arrows

Owned by dani.simmonds
Aug 15, 2024
2 min read

Move Origin Arrows

Move Origin Arrows

  • Use the Origin Arrows to move the current design on the Cut Preview screen a full Design Width/Height distance. This allows you to cut consecutive mats when calibrating, or using up scrap mats, etc.

  • Click on the design to select it.

  • The Move Origin Arrows (Up, Down, Left or Right) moves the current design by a full design's outside Width or Height in the direction of the arrow.

  • For example, clicking the Right Arrow will move the design over the same full design width to the Right, so that it can be cut next to the previous cut that was made with this design.

The Previous Cuts are displayed on the Cut Preview as Faded Gray outlines.

These allow you to position the next cut beside a previous cut when cutting several designs from the same mat, such as when Calibrating the CMC.

This can be turned on/off in the Options menu, and the previous cuts can be cleared from the screen with the Clear Cut History button.

Click Clear Cut History to Wipe the Current Cut History Images

See: Previous Cuts Toggle

See: Clear Cut History

Use the Move Origin Arrows Button to Move the Design the Design’s Width or Height in the Direction of the Arrow