Shared Edge: Cut Mode Advanced Options

Select Shared Edge from the Cut Mode dropdown control to cut the shared edges of the Outside cuts as a single cut on the CMC Z1, Z (9000z), 9000 and 8000+.

Click the Set Advanced Options button to access the Advanced Outside Options. 

Select Shared Edge from the Cut Mode dropdown control to cut the shared edges of the outside cuts in one stroke. 

If cutting a single design, it will cut only the Top and Right lines of the Outside cut, thus not wasting any matboard since the CMC Z1 and Z (9000z) can cut right to the edges. 

If cutting a Tiled mat, this will cut the Outside shared lines between the designs as a single cut, rather than cutting each design's Outside edge individually.

When Tiling, make sure that Spacing under the Setup Tab is set to zero (0) so that it shares the Outside cut line with the next design, and only cuts the one line between them.

The shared Outside edges of the Tiled design will cut in one stroke between the designs. 

If you have Remnant Trimming on, it will also cut off the scrap edge.

• Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.