• The Drive Belts are located within the top and bottom Board Rails and ensure precise control of the Gantry’s Horizontal movement.

  • It is important that the Red Lines on the Drive Belts and Toothed Pulley line up together.

Connections:

• The Drive Belts attach to the Board at the Belt Anchors on the left end of the top and bottom Board Rails, then run Horizontally along the Board Rails and then through the Toothed Pulley of the Drive Shaft of the Gantry and are anchored by the Horizontal Tension Adjustments on the right side of the Board.

  • Make sure that the Red Lines on the Drive Belts and Toothed Pulley line up together.

Troubleshooting:

• The cuts are cutting crooked:

  • Make sure that the Red Lines on the Drive Belts and Toothed Pulley line up together. If the Red Lines do not line up, the Drive Belt needs to be realigned: Drive Belt Position Alignment.

• The Drive Belt is becoming frayed.

  • Order and replace the Drive Belts: Drive Belt Replacement