">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 5 Next »

Quick Calibration Home Adjustments: Vertical Home

Contents:

  • Measure the bottom border to the opening viewed from the cutting side of the mat; this example was cut from the back. If it is not 2”, adjust the Vertical Home.

  • If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

  • If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

  • The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges, viewed as it was cut.

    • If Opening cuts Too Far Up Vertically, Decrease the Vertical Home.

    • If Opening cuts Too Far Down Vertically, Increase the Vertical Home.

VerticalHomeBack70800.png

Full Definition: Vertical Home Definition

🛠️ Click the Minus [-] or Plus [+] button in the desired field several times, perform a test cut, and continue adjusting until satisfied.

  • No labels