Select Full from the Outside Cut Options dropdown control to cut the full outside edges of the design on the CMC Z1 and Z (9000z).

Select Full from the Outside Cut Options dropdown control to cut the complete outside edge of the design.

When tiling mats, it will cut out the complete outside edge of each design.

If you have Remnant Trimming on, it will also cut off the scrap edge.

Optionally, click Set Advanced Options to access the Advanced Outside Cut Options.

Set Cut Mode to Full. The Cut Mode matches the selections from the Outside Cut Options as described above.

The full outside edge of the design or tiled designs will be cut. 

If you have Remnant Trimming on, it will also cut off the scrap edge.

The default setting for Cutting the Outside can be set in the Admin > Editor section.

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

The default setting for the Advanced Options can be set in the Admin > Cutting section.

The default setting for the Cut Mode can be set in the Admin > Cutting section.