Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts on the CMC Z1 and Z (9000z).

Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts as one stroke between the designs instead of cutting the outside of each mat individually.   

If cutting a single design, it will cut only the top and right lines of the outside cut, using the factory edge for the left and bottom edges of the mat, thus not wasting any matboard since the Z1 and Z (9000z) can cut right to the edges. 

If cutting a tiled mat, this will cut the outside shared lines between designs as one cut, rather than cutting each design's outside edge individually.

When Tiling, make sure that the Spacing under the Setup Tab is set to zero (0) so that each design shares the outside lines with the next design, so it will only cut the single line between them. 

If you have Remnant Trimming on, it will also cut off the scrap edge.

Optionally, click Set Advanced Options to access the Advanced Outside Cut Options.

Set the desired Cut Mode to select how the outside cut will be cut. These match the selections from the Outside Cut Options as described above.

The default setting for Cutting the Outside can be set in the Admin > Editor section.

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

The default setting for the Advanced Options can be set in the Admin > Cutting section.

The default setting for the Cut Mode can be set in the Admin > Cutting section.