This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Current »

Cut Pattern 

Select the desired cut pattern from the Cut Pattern dropdown control when cutting a tiled mat on the CMC Z1 and Z (9000z).

Set Advanced Options

Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options.  

Make the desired selection from the Cut Pattern dropdown control as described below.  

Click OK.

The CMC will use these settings when cutting a tiled mat.

Optimized Cut Pattern

Select this topic to see information on the Optimized Cut Pattern.

Unidirectional Cut Pattern

Select this topic to see information on the Unidirectional Cut Pattern.

Stairstep Cut Pattern

Select this topic to see information on the Stairstep Cut Pattern.

  • No labels