Page Comparison

Crease Overcut is Too Long

Panel

For Additional Information: See Using the Configuration Backup and Overcut Display on the : Cut Preview for Troubleshooting.

Expand

title	Overcut of Creases Definition

The Overcut controls where the cartridgeRetracts from the Matboard.
- If the Overcut is cut Too Long, Decrease the Overcut.
- If the Overcut is cut Too Short, Increase the Overcut.
The Overcut field is marked with a Red Arrow on the Configuration screen and the Map/wiki/spaces/FrameShop8x/pages/1942503207illustration.

See: Overcut for Creases Configurations

Expand

title	How to Adjust the Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.