You are viewing an old version of this content. View the current version.
Compare with Current View Version History
Version 1 Next »
If the Overcut is Too Long, Decrease the Overcut.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
The Overcut controls where the cartridge Retracts from the Matboard.
If the Overcut is cut Too Long, Decrease the Overcut.
If the Overcut is cut Too Short, Increase the Overcut.
The Overcut field is marked with a Red Arrow on the Configuration screen and the Map/wiki/spaces/FrameShop8x/pages/1942503207illustration.
See: Overcut for Creases Configurations
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
