This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 16 Current »

Full Cut Mode

Select Full on the Cut Mode dropdown control to cut the complete outside edges of the design on the CMC Z1 and Z (9000z).

Click the Set Advanced Options button to access the Advanced Outside Options. 

Select Full from the Cut Mode dropdown control.

The full outside edge of the design or tiled designs will be cut. 

If you have Remnant Trimming on, it will also cut off the scrap edge.

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Set the Default for the Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for the Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section. 

  • No labels