Click here to check out our new How To section

Auto Remnant Trimming: Cutting Default Setting

Owned by dani.simmonds

Last updated: Sept 26, 2024

1 min read

Auto Remnant Trimming: Cutting Default Setting

Auto Remnant Trimming: Cutting Default Setting

Select Auto for the Remnant Trimming to default to letting the software determine the best direction to cut off the Remnant piece.
- Using this setting, the design will trim the remnant from the matboard by automatically selecting the optimum direction: Vertically or Horizontally.

Select Auto for the Remnant Trimming to default to letting the software determine the best direction to cut off the Remnant piece.

For Additional Information: See Remnant Trimming in the Set Advanced Options section on the Cut Preview.

Default Setting for Having the Remnant Trimming Auto

Remnant Trimming Auto Will Automatically Determine the Best Direction to Trim the Remnant