This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 21 Next »

Horizontal Home for Openings

The Horizontal home defines the global horizontal placement of objects cut with the blade cartridges.  

Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big

Adjust the Horizontal home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.

The opening is cutting too far to the right.

Decrease the Horizontal home.

When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small

Adjust the Horizontal home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.

The opening is cutting too far to the left.

Increase the Horizontal home.

When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Horizontal Home Troubleshooting

Alternatively, adjust the Horizontal home on the Troubleshooting Screen.

Adjusting the Horizontal Position for Non-Blade Cartridges

To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, Pen or Vinyl tools), see Horizontal Adjustment.

  • No labels