Cut the Outside Toggle |
---|
Use the Cut the Outside toggle to select cutting or not cutting the outside of the mat. |
Cut the Outside On | |
---|---|
Click the Cut Outside toggle On to cut the outside of the mat. The outside of the mat will now cut. |
Cut the Outside Off | |
---|---|
Click the Cut Outside toggle Off to not cut the outside of the mat. The outside of the mat will not be cut. |
Set Advanced Options: Enable Outside Cut | |
---|---|
Optionally, select this topic to see information on Enabling Outside Cut on the Advanced Outside Options. |
Set the Default for Cutting the Outside | |
---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section. |
Set the Default for 90 Degree Outside Cut | |
---|---|
The default setting for 90 Degree Outside can be set in the Admin > Cutting section. Note that the CMC 8000 cannot support cutting with the 90 Degree Outside. |
Enable Auto Clamp Offset | |
---|---|
Select Enable Auto Clamp Offset checkbox to move the design up and over on the matboard to avoid the clamp area on the CMC Z1 and Z (9000z), similar to the Rail Dodge below. | |
Check the Enable Auto Clamp Offset checkbox. Enter the distance to move the design in the X Origin field; the Y Origin field uses the same number value. It will move the lower left corner of the design to the new X/Y position and it will display Dodge on the bottom of the screen. This feature is also turned on by selecting Full from the Outside Cut Options dropdown control. |
Disable Auto Clamp Offset | |
---|---|
Disabling the Auto Clamp Offset will cut the design normally without being offset into the mat on the CMC Z1 and Z (9000z). | |
Uncheck the Auto Clamp Offset checkbox. The design will no longer be offset on the CMC Z1 and Z (9000z) and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above. |
Set the Default for the Enable Auto Clamp Offset | |
---|---|
The default setting for the Enable Auto Clamp Offset for the CMC Z1 and Z (9000z) can be set in the Admin > Cutting section. |
Enable Rail Dodge | |
---|---|
The Enable Rail Dodge checkbox will move the design up and over on the matboard to avoid the clamping area on the CMC 8000 and 9000, similar to the Enable Auto Clamp Offset above. | |
Check the Enable Rail Dodge checkbox to use a Rail Dodge on CMC 8000 and 9000. This is similar to the Enable Auto Clamp Offset above. A Rail Dodge is a small piece of matboard or other material used to position the pre-cut matboard up into the cutting area when using borders less than 1.5" and not cutting the outside. Enter the distance to move the design in the X Origin field; the Y Origin field uses the same number value. It will move the lower left corner of the design to the new X/Y position and it will display Dodge on the bottom of the screen. Note: The outside cut is shown here merely for visual reference of where the pre-cut matboard will be positioned on the board. This feature can also be used to move the design to avoid flaws in the matboard. See Also: Fixture for Rail Dodge. |
Disable Rail Dodge | |
---|---|
Disabling the Rail Dodge will now cut the designs normally without being offset up and over on the mat. | |
Uncheck the Rail Dodge checkbox. The design will no longer be offset on the CMC 8000 and 9000 and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above |
Set the Default for the Rail Dodge | |
---|---|
The default setting for the Rail Dodge can be set in the Admin > Cutting section. |