You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 3 Next »
Select Off to default to not using the Remnant Trimming after cutting the mat.
Using this setting, the design will cut, but not trim off the remnant from the matboard.
Select Remnant Trimming to Off to default to not cutting the remnant of the sheet of matboard afterwards.
For Additional Information: See Remnant Trimming in the Set Advanced Options section on the Cut Preview.
Remnant Trimming: Advanced Options
Remnant Trimming: Auto: Remnant Trimming Advanced Options
Remnant Trimming: Horizontal: Remnant Trimming Advanced Options
Remnant Trimming: Off: Remnant Trimming Advanced Options
Remnant Trimming: Vertical: Remnant Trimming Advanced Options
Auto Remnant Trimming: Cutting Default Setting
Horizontal Remnant Trimming: Cutting Default Setting
Remnant Trimming: Cutting Default Setting
Remnant Trimming Off: Cutting Default Setting
Vertical Remnant Trimming: Cutting Default Setting
