">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Current »

Tool Line Too Far Down

  • If the Non-Blade Tool line is applied Too Far Down Vertically, Increase the Vertical Adjustment.

šŸ› ļø Click the Plus or Minus button several times on the desired field, do a test cut and continue adjusting until satisfied.

Vertical Adjustment for Non-Blade Cartridges Definition

  • TheĀ Vertical AdjustmentĀ defines the global Vertical placement of objects applied with the Non-Blade Tool Cartridges.

    • If Non-Blade line is applied Too Far Up Vertically, Decrease the Vertical Adjustment.

    • If Non-Blade line is applied Too Far Down Vertically, Increase the Vertical Adjustment.

ToolVertAdj70800.png

Full Definition: Vertical Adjustment for Non-Blade Cartridges Definition

ToolVertAdjMoveUp70800.png
  • No labels