">

Click here to check out our new How To section">Click here to check out our new How To section

Skip to end of banner Go to start of banner

Opening Adjustment on Crease: Configurations Screen

Skip to end of metadata

Created by dani.simmonds, last modified on Nov 11, 2024

Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Opening Adjustment on Creases

Contents:

If the Crease is Too Large, Decrease the Opening Adjustment.
If the Crease is Too Small, Increase the Opening Adjustment.

🛠️ Click the Plus or Minus button several times on the desired field, do a test cut and continue adjusting until satisfied.

Opening Adjustment Definition

The Opening Adjustment controls the size of the Opening cut or applied with non-blade cartridges.
- If Opening cuts Too Large, Decrease the Opening Adjustment.
- If Opening cuts Too Small, Increase the Opening Adjustment.

Full Definition: Opening Adjustment Definition

For Additional Information: Troubleshooting Utility for the Configurations

No labels