">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 95 Next »

Troubleshooting Utility for Editing the Configurations

  • Use the Troubleshooting Utility to make quick edits to the Configurations.

Contents:

TroubleshootingButton70800.png

Calculate Home Adjustments

  1. Cut a one layer rectangle opening without Cutting the Outside. 

  2. From the front of the mat, measure the Right and Bottom borders from the inside of the bevel to the edge of the mat.

  3. Enter those values into the Act Right Border (Actual Right Border) and Act Btm Border (Actual Bottom Border) fields.  

  4. Click on the Calc Home Adjustments button to recalculate and adjust the Horizontal and Vertical positions.

  5. Do a test cut to confirm that it is correct and readjust if necessary.

  • For Additional Information:

  • See Horizontal Home which defines the global Horizontal placement of objects cut with the Blade Cartridges.

  • See Vertical Home which defines the global Vertical placement of objects cut with the Blade Cartridges.

 Horizontal Home General Definition

The Horizontal Home defines the global Horizontal placement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Left Horizontally, Increase the Horizontal Home.

If the Opening is cut Too Far Right Horizontally, Decrease the Horizontal Home.

See: Horizontal Home for Openings Configurations

See: Horizontal Home for V-Grooves Configurations

 Vertical Home General Definition

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

See: Vertical Home for Openings Configurations

See: Vertical Home for V-Grooves Configurations

Calculate Opening Adjustments

  1. Cut a one layer rectangle opening. 

  2. From the front of the mat, measure the Width and Height of the opening from the inside of the bevel. 

  3. Enter those values into the Actual Height and Actual Width fields. 

  4. Click on the Calc Opening Adjustment button to recalculate and adjust the Opening Adjustment value. 

  5. Do a test cut to confirm that it is correct and readjust if necessary.

  • For Additional Information:

  • See Opening Adjustment for information on adjusting the object’s size.

 Opening Adjustment General Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Opening is cut Too Large, Decrease the Opening Adjustment.

If the Opening is cut Too Small, Increase the Opening Adjustment.

See: Opening Adjustment for Openings Configurations

See: Opening Adjustment for Drops Configurations

See: Opening Adjustment for Outsides Configurations

See: Opening Adjustment for V-Grooves Configurations

See: Opening Adjustment for Deboss Configurations

See: Opening Adjustment for Pens Configurations

See: Opening Adjustment for Vinyls Configurations

See: Opening Adjustment for Creases Configurations

  • No labels