">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 17 Next »

Line Design Details

  • Click on a Line to see the specific details about it. 

 Line Tool Definition

The Line tool in Trace will draw a Two-Point Line. 

The Line is defined by two points: Initial Position (called an Anchor) and the Terminating Position (called an Anchor).

After it is drawn, a third point in the Center will be displayed, which can be moved to alter the line into an Arc.

  • The Design Details section displays information about the selected line.

Design Line Details

Start X and Start Y

  • Displays the Start X/Y Coordinates of the object’s start point when drawn.

    • If you clicked on the upper left and drew by dragging to the lower right, that would make the start point the upper left corner. 

 X Position Definition

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

 Y Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

Mid X and Mid Y 

  • The Middle Point X and Y Coordinates.

 X Position Definition

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

 

 Y Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

 

End X and End Y 

  • The End Point X and Y Coordinates.

 X Position Definition

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

 Y Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

Angle 

  • This displays the Angle, in degrees, of the Line.

  • The Angle is the space, in degrees, between a given line and an unseen horizontal line intersecting its end point. 

Length 

  • Displays the Length of the Line in the current dimensions.

Bevel Type 

 Bevel Type Definition

The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

 Traced Definition

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply with a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

See: Tracing the Design

Layer 

 Traced Definition

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply with a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

See: Tracing the Design

  • No labels