Crease Cartridge | |
|---|---|
The Crease Cartridge creases the material to make folding it easier when making Boxes. |  |
Crease Tab | |
|---|---|
Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab. |  |
Crease Exterior Backup is too Long | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup. |  |
Crease Exterior Backup is too Short | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup. |  |
Crease Exterior Overcut is too Long | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut. |  |
Crease Exterior Overcut is too Short | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut. |  |
Crease is the Wrong Size | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Opening Adjustment. |  |
Crease Cuts the Wrong Depth When Using a SKU | |
|---|---|
Select this topic to see information on editing the Depth Bias. |  |
Troubleshooting Button | |
|---|---|
Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. |  |
Set Box Defaults | |
|---|---|
Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software. |  |