This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

Vertical Adjustment

Use the Vertical Adjustment if the non-blade tool (Deboss, Pen or Vinyl) is being applied to the wrong place vertically.

Select the Tool and Type

Make sure to select the desired tool from the Cartridge Type Tab and then the tool type you want to edit from the Current Bevel Type dropdown control, if applicable, before making adjustments.

Tool Line Too Far Down

The tool line is applied too far down.

Increase the Vertical Adjustment to move the tool line up.

Tool Line Too Far Up

The tool line is applied too far up.

Decrease the Vertical Adjustment to move the tool line down.

Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Make sure that the opening is being cut in the correct place. If the opening is cutting in the wrong place Vertically when you are not cutting the outside of the mat, see Vertical Home.

  • No labels