">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

Version 1 Next »

Quick Calibration Home Adjustments: Vertical Home

Measure the bottom border to the opening viewed from the cutting side of the mat; this example was cut from the back. If it is not 2”, adjust the Vertical Home.

  • If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

  • If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

Contents:

 Vertical Home General Definition

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

See: Vertical Home for Openings Configurations

See: Vertical Home for V-Grooves Configurations

  • No labels