How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Deboss Wide Configurations

The Blue Deboss Wide Cartridge presses a wide stylus into the matboard to create a subtle design.

Select the Deboss Wide Cartridge Type

Select the Deboss Tab on the Configurations screen.  

Select the Wide-Blue cartridge from the Cartridge dropdown control.

Select the Area of Concern for Wide Deboss Below:

Be sure to select the Deboss Wide from the Current Bevel Type dropdown control.

Deboss-Wide is Applied to the Wrong Place Horizontally

Deboss-Wide is Applied to the Wrong Place Vertically 

  • This is viewed from the front of the mat.

  • Select this topic to adjust the Vertical Adjustment.

Deboss-Wide is the Wrong Size

  • This is viewed from the front of the mat.

  • Select this topic to adjust the Opening Adjustment.

Deboss-Wide Applied at the Wrong Depth

Deboss-Wide Cartridge Tears the Mat 

Deboss-Wide Lines are too Long

  • This is viewed from the front of the mat.

  • Select this topic to adjust the Overshoot.

Deboss-Wide Lines are too Short 

  • This is viewed from the front of the mat.

  • Select this topic to adjust the Overshoot.

Deboss-Wide Set to Plunge Between Segments

  • Select this topic to adjust the Plunge between segments.

Troubleshooting Button 

  • No labels