Troubleshooting Utility for Editing the Configurations | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
Panel | | ||||||||||||||
| |||||||||||||||
See Circle/Oval Rotation Utility to adjust for a Feather or Bump in an Oval.
Calculate Home Adjustments
Cut a one layer rectangle opening without Cutting the Outside.
From the front of the mat, measure the Right and Bottom borders from the inside of the bevel to the edge of the mat.
Enter those values into the Act Right Border (Actual Right Border) and Act Btm Border (Actual Bottom Border) fields.
Click on the Calc Home Adjustments button to recalculate and adjust the Horizontal and Vertical positions.
Do a test cut to confirm that it is correct and readjust if necessary.
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
|
| title | Horizontal Home General Definition |
|---|
If the Opening is cut Too Far Left Horizontally, Increase the Horizontal Home.
If the Opening is cut Too Far Right Horizontally, Decrease the Horizontal Home.
See: Horizontal Home for Openings Configurations
See: Horizontal Home for V-Grooves Configurations
| Expand | ||
|---|---|---|
| ||
The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges. If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home. If the Opening is cut Too Far Down Vertically, Increase the Vertical Home. |
Calculate Opening Adjustments
Cut a one layer rectangle opening.
From the front of the mat, measure the Width and Height of the opening from the inside of the bevel.
Enter those values into the Actual Height and Actual Width fields.
Click on the Calc Opening Adjustment button to recalculate and adjust the Opening Adjustment value.
Do a test cut to confirm that it is correct and readjust if necessary.
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
|
| Expand | ||
|---|---|---|
| ||
The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges. If the Opening is cut Too Large, Decrease the Opening Adjustment. If the Opening is cut Too Small, Increase the Opening Adjustment. See: Opening Adjustment for Openings Configurations See: Opening Adjustment for Drops Configurations See: Opening Adjustment for Outsides Configurations See: Opening Adjustment for V-Grooves Configurations See: Opening Adjustment for Deboss Configurations See: Opening Adjustment for Pens Configurations |