Content Comparison

• The Blue Deboss Wide Cartridge presses a wide stylus into the matboard to create a subtle design.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

Select desired Cartridge Tab. 

Select the desired Deboss Cartridge Size from Current Bevel Type.

Edit the desired Configuration field.

Image Removed

• Non-Blade Tool line is applied too far Left:

  • Increase the Horizontal Adjustment.

• Non-Blade Tool line is applied too far Right:

  • Decrease the Horizontal Adjustment.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Deboss-Wide is applied to the wrong place Vertically.

• Non-Blade Tool line is applied too far Up:

  • Decrease the Vertical Adjustment.

• Non-Blade Tool line is applied too far Down:

  • Increase the Vertical Adjustment.

The Vertical Adjustment defines the global Vertical placement of objects applied with the Non-Blade Tool Cartridges.

If the Non-Blade Tool line is applied Too Far Up, Decrease the Vertical Adjustment.

If the Non-Blade Tool line is applied Too Far Down, Increase the Vertical Adjustment.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Opening cuts too Large:

  • Decrease the Opening Adjustment.

• Opening cuts too Small:

  • Increase the Opening Adjustment.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Opening is cut Too Large, Decrease the Opening Adjustment.

If the Opening is cut Too Small, Increase the Opening Adjustment.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Deboss-Wide is applied at the Wrong Depth.

• Non-Blade Tool is too Deep:

  • Decrease the Depth Setting.

• Non-Blade Tool is too Shallow:

  • Increase the Depth Setting.

• Non-Blade Tool is Tearing in the Corners of the segments:

  • Increase the Corner Pause. 

• Non-Blade Tool is Pausing Too Long in the Corners of the segments:

  • Decrease the Corner Pause. 

• Decrease the Overshoot.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Increase the Overshoot.

• Use the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure.

• Non-Blade Tool leaves a Dot where it plunges:

  • Select Unplunge.

• Non-Blade Tool takes Too Long to apply:

  • Select Plunge.

The Plunge function controls whether to Plunge/Unplunge between the Line/Arc Segments of an object when applying a Non-Blade Tool.

The Non-Blade Tool leaves a Dot where it plunges, select Unplunge.

The Non-Blade Tool takes Too Long to apply, select Plunge.