Content Comparison

First we need to make sure we are designing the layers in the correct order for these instructions.

On the FrameShop Main Page, click Admin and stay on the Defaults tab.

Under Layer Direction select Bottom Up if it is not already set to that.

Click Save and return to the Main Page.

• You can change this back to the original setting later if desired.

Place a two Layer 4 x 5 #906 Rectangle Key Template on the FrameShop Design Editor. 

Click on Properties.

Click on the Key tab.  

Change the Key Reveal to .5” (1/2").

• This reveal will be part of the V-Groove.

Click on the Parameters tab.

Change the NPHeight to .75" (3/4").

Change the Distance of the Key to 1.25" (1 1/4").

Click the Positioning Toggle to position objects from the Bottom Layer.

Make sure that the opening is selected.

Click on the Openings tab. 

Click the Add V-Groove button.  

Enter 1" for the Offset value and click OK.

Click on the V-Groove to resize it.   

Pull down the Bottom Line of the V-Groove and let it snap to the Horizontal Guideline that we placed.

• Make sure you are dragging the Bottom Line of the V-Groove and not just moving the whole V-Groove.

Release the mouse to place it.

Stay on the Trace and Draw tab and go down to the Edit section.

Hold down the CTRL key and click on the V-Groove and the outside line of the Nameplate.

Click the Break button.

The Intersections are now broken where the Lines crossed over each other.

Hold down the CTRL key and click on the Top Half of the Nameplate then the Bottom Half of it, then on the Outside V-Groove. 

Click the Join button.

The lines are Joined together to create a single object.