Versions Compared

Old Version 2

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Push to Cut Button Definition

Panel
panelIconIdatlassian-plus
panelIcon:plus:
panelIconText:plus:
bgColor#FFFAE6

  • The Push to Cut Button allows the user to cut the current design on the Cut Preview Screen without returning to the computer.

  • If required, you will be asked to Align the Head. 

  • During cutting, you can also use the Push to Cut Button to pause the cut.

Tip

Connections:

  • The Push to Cut Button is usually located on the Control Panel on the left side of the Board for CMCs that include this feature.

  • If required, you will be asked to Align the Head. 

    • During cutting, you can also use the Push to Cut button to pause the cut
Warning

Troubleshooting:

  • Pushed the Push to Cut Button and it doesn’t cut.

    • Check to make sure the Emergency Stop Button isn’t pressed in.

    • Are the connection cables for the ECUon tight?

    • Are the connection cables for the ECU/Driver Pack, Gantry, Computer and Control Panel (if appropriate) on tight?

    • Turn off the ECU/Driver Pack close the software. Turn on the ECU/Driver Pack restart the software.

    • If clicking Cut on the Cut Preview screen works but pushing the Push to Cut Button does not, contact Technical Support.