Vertical Adjustment | |
|---|---|
Use the Vertical Adjustment if the non-blade tool (Deboss, Pen or Vinyl) is being applied to the wrong place vertically. |   |
Select the Tool and Type | |
|---|---|
Make sure to select the desired tool from the Cartridge Type Tab and then the tool type you want to edit from the Current Bevel Type dropdown control, if applicable, before making adjustments. |  |
Tool Line Too Far Down | |
|---|---|
The tool line is applied too far down. |   |
Increase the Vertical Adjustment to move the tool line up. |   |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |   |
Tool Line Too Far Up | |
|---|---|
The tool line is applied too far up. |   |
Decrease the Vertical Adjustment to move the tool line down. |  |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Opening Cuts in the Wrong Place Vertically when not cutting the Outside | |
|---|---|
Make sure that the opening is being cut in the correct place. If the opening is cutting in the wrong place Vertically when you are not cutting the outside of the mat, see Vertical Home. |   |