Page Comparison

The 45° metal blade cartridge* is designed to cut standard 4-ply matboard. The 45° blade cartridge does not support blade depths above 16.

*Older systems may have a 45° plastic cartridge.

Selecting the 45 Degree Blade Cartridge in the Software: CMC Z1, Z (9000z), 9000 and 8000

Select this topic to see information on Selecting the 45 Degree Blade Cartridge in the Software.

Selecting the 45 Degree Blade Cartridge Outside Cut on the CMC Z1-Z (9000z)

Select this topic to see information on Selecting the 45 Degree Blade Cartridge Outside Cut on the CMC Z1-Z (9000z).

Selecting the 45 Degree Blade Cartridge Outside Cut on the CMC 9000-8000

Select this topic to see information on Selecting the 45 Degree Blade Cartridge Outside Cut on the CMC 9000-8000.

Air Pressure for Cutting with the 45 Degree Blade Cartridge with the CMC Z1, Z (9000z), and 9000 

Select this topic to see information on adjusting the Air Pressure for Cutting with the 45 Degree Blade Cartridge to cut typical matboard or dense matboard material.

Changing the Blade on the 45 Degree Cartridge on the CMC Z1, Z (9000z), 9000 and 8000

Select this topic to see information on Changing the Blade on the 45 Degree Cartridge.

Changing to the 45 Degree Blade Cartridge on the CMC Z1, Z (9000z), 9000 and 8000

Select this topic to see information on Changing to the 45 Degree Blade Cartridge.

Editing the 45 Degree Configurations on the CMC Z1, Z (9000z), 9000 and 8000  

Select this topic to see information on Editing the 45 Degree Configurations.