Page Comparison

Troubleshooting Utility for Editing the Configurations

Use the Troubleshooting Utility to make quick edits to the Configurations.

Cut a one layer rectangle opening without Cutting the Outside.
From the front of the mat, measure the Right and Bottom borders from the inside of the bevel to the edge of the mat.
Enter those values into the Act Right Border (Actual Right Border) and Act Btm Border (Actual Bottom Border) fields.
Click on the Calc Home Adjustments button to recalculate and adjust the Horizontal and Vertical positions.
Do a test cut to confirm that it is correct and readjust if necessary.

Panel

For Additional Information:
See Horizontal Home which defines the global Horizontal placement of objects cut with the Blade Cartridges.
See Vertical Home which defines the global Vertical placement of objects cut with the Blade Cartridges.

Expand

title	Horizontal Home General Definition

The Horizontal Home defines the global Horizontalplacement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Left Horizontally, Increase the Horizontal Home.

If the Opening is cut Too Far Right Horizontally, Decrease the Horizontal Home.

See: Horizontal Home for Openings Configurations
See: Horizontal Home for V-Grooves Configurations

Expand

title	Vertical Home General Definition

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

See: Vertical Home for Openings Configurations

See: Vertical Home for V-Grooves Configurations

...