Page Comparison

The Deboss Medium Red cartridge stylus presses onto the surface of the matboard to create a subtle design with a Medium line.

There are three Deboss stylus sizes: Wide, Medium, Thin.

In addition to Template Shapes, you can also Deboss CutArts, LetterMats and TTFs.

Image Removed

Image Added

See: Add Deboss Opening Function

• For Additional Information: See Depth Setting for information on adjusting the Depth of the Non-Blade Tool.

The Depth Setting controls the Blade Depth for theNon-Blade Tools in the Configurations.

If the Non-Blade Tool is too Deep, Decrease the Depth Setting.

If the Non-Blade Tool is too Shallow, Increase the Depth Setting.

Image Modified

See: Depth Setting for Deboss.

• For Additional Information: See Overshoot for information on adjusting the Overshoot of the Non-Blade Tool in the corners.

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.

This is similar to the Overcut used with the Blade cartridges.

See: Overshoot for Deboss.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• For Additional Information: See Plunge (Tool Specific) for information on adjusting the Plunging of the Non-Blade Tool in the corners.

The Plunge function controls whether to Plunge/Unplunge between the Line/Arc Segments of an object when applying a Non-Blade Tool.

The Non-Blade Tool leaves a Dot where it plunges, select Unplunge.

The Non-Blade Tool takes Too Long to apply, select Plunge.

This is different from the Plunge Count which controls the number of Blade Plunges for each Blade Cartridge before pausing for a Blade Change.

See: Plunge for Deboss.