Page Comparison

• If the Crease is Too Large, Decrease the Opening Adjustment.

• If the Crease is Too Small, Increase the Opening Adjustment.

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Crease is Too Large, Decrease the Opening Adjustment.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Crease is Too Large, Decrease the Opening Adjustment.

Image Modified

Image Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Crease is Too Small, Increase the Opening Adjustment.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Crease is Too Small, Increase the Opening Adjustment.

Image Modified

Image Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Crease is Too Large, Decrease the Opening Adjustment.

• If the Crease is Too Small, Increase the Opening Adjustment.

• Enter the measured height and width of the opening into the appropriate fields and clicking the Calc Opening Adjustment button. 

• Make sure that only a single opening is present on the screen, otherwise the Troubleshooting Button will be grayed out.