...
Trace the Design | |
|---|---|
Because this design contains no arcs, there is no need to tangify it or convert into arcs. Click the Set Bevels tab. Select the top layer which is displayed at the top of the layer list regardless of the actual layer number. Click on the new V-Groove object to select it. Click the 45° V-Groove Set button. |  |
The V-Groove is traced. |  |
Click on the nameplate opening. Click the 45° Bevel Set button. |  |
The nameplate opening is now traced on the top layer. |  |
...
If the CutArt Flows Off the Mat: | |
|---|---|
If you load the CutArt into the Design editor and part of it flows off of the mat even with Dynamic Outsides on, check the Border direction. Click on one of the Border lines. Click on the Properties tab to get the Border properties. Change Apply Borders To: Top Layer. |  |
Click on the design to readjust it with the Dynamic Outsides on. |  |
...