Pick a spot on the wall that is at least 7 feet wide, or 9 feet if putting the computer on a stand alongside the Wizard.
Find two wall studs 48” apart towards the right side of the area.
The two shelf standards will mount on these studs.
The Wizard is 72” wide and it will rest on a shelf 48” wide.
If there is a choice, it is preferable to locate the left end of the machine closer to the support.
Measure up from the floor 68 inches at those two studs.
Use a level to make sure they are at the same level and not following a sloping floor.
Before mounting, make sure both Standards are facing the same direction (as the holes start off in a different position on each end).
Mount one of the shelf standards onto the wall using 2 ½” flat head screws, centering it over the 48” mark.
The top of the standard should be at the 68” mark.
Pre-drill into the studs, if you like, using a 7/64” drill.
Start at the top and use the level to make sure it is straight up and down.
Mount the second standard just the same, centering it over the other 48” mark.
Be careful to make sure that the two standards are 48” apart at the center point.
