Bump on an Oval V-Groove
The Outside Oval Rotation for V-Grooves controls for Feathers or Bumps on the Outside Cut of an Oval V-Groove. A Bump in the Outside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on the Outside cut of the Oval V-Groove. If the Outside cut of the Oval V-Groove cuts with a Bump, Decrease the Outside Oval Rotation. Bump on the Outside Cut of the Oval V-Groove Outside Oval Rotation for V-Grooves The Inside Oval Rotation for V-Grooves controls for Feathers or Bumps on the Inside Cut of an Oval V-Groove. A Bump in the Inside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on either the Inside Cut of the Oval V-Groove. If the Inside cut of the Oval V-Groove cuts with a Bump, Increase the Inside Oval Rotation. When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. For Oval Openings, see Bump on an Oval Definition. |