">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 30 Current »

Troubleshooting the Backup/Overcut Display: Cut Preview

  • Have a cut design displayed on the Cut Preview.

  • Note that this feature is only available for the Bladed Cartridges.

  • Using one of the Zoom buttons, zoom in to the desired section of the project where you are having issues cutting.

  • Make sure that the Green Backups and Red Overcuts lines are visible.

Exterior Backup Definition

  • The Exterior Backup on the Opening adjusts the Blade’s Plunge (Backup) into the Matboard (Exterior).

    • If the Exterior Backup leaves Hooks in the corner, Increase the Exterior Backup.

    • If the Exterior Backup cuts Too Long, Decrease the Exterior Backup.

    • If the Exterior Backup cuts Too Short, Increase the Exterior Backup.

BackupOvercutEBArrows70800.png

Full Definition: Exterior Backup Definition

Interior Backup Definition

  • The Interior Backup for Openings adjusts the Blade’s Plunge (Backup) into the Fallout (Interior).

    • If the Interior Backup cuts Too Long, Decrease the Interior Backup.

    • If the Interior Backup cuts Too Short, Increase the Interior Backup.

BackupOvercutIBArrows70800.png

Full Definition: Interior Backup Definition

Exterior Overcut Definition

  • The Exterior Overcut on the Opening adjusts the Blade’s Withdrawal (Overcut) from the Matboard (Exterior).

    • If the Exterior Overcut cuts Too Long, Decrease the Exterior Overcut.

    • If the Exterior Overcut cuts Too Short, Increase the Exterior Overcut.

BackupOvercutEOArrows70800.png

Full Definition: Exterior Overcut Definition

Interior Overcut Definition

  • The Interior Overcut for Openings adjusts the Blade’s Withdrawal (Overcut) from the Fallout (Interior).

    • If the Interior Overcut cuts Too Long, Decrease the Interior Overcut.

    • If the Interior Overcut cuts Too Short, Increase the Interior Overcut.

BackupOvercutIOArrows70800.png

Full Definition: Interior Overcut Definition

  • With the cursor hovering over one of the Backups or Overcuts, the Status Bar displays the actual physical length of the selected Backup or Overcut.

  • This value will be the Sum of the corresponding User Configuration setting and the Factory Configuration setting.

  • The Configuration screen will open to the appropriate Cartridge Tab with the Configuration Field associated to the line clicked highlighted.

  • Now you can easily adjust the value displayed, depending upon whether the item selected is cutting Too Short or cutting Too Long.

    • Increase the value if the item is cutting Too Short.

    • Decrease the value if the item is cutting Too Long.

  • Click OK and recut the design.

  • Continue adjusting the Configurations until you achieve the desired result.

  • To adjust, click Plus/Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

  • No labels