Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 20
Next »
The 45° Front Outside is created by cutting into the front of the fallout surface with the blade angled at 45°, thereby slanting the bevel under the fallout surface. The matboard core is not visible from the front. The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut. The 45° Front Blade Cartridge is not selected within the Editor; it is set by using Cut From Front on the Cut Preview. Select Outside-Front of Mat from the Current Bevel Type dropdown control to edit this configuration.
|  |