">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

V-Groove Outside Cut has a Bump

 Outside Oval V-Groove Bump Definition

A Bump in the Outside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on the Outside cut of the Oval V-Groove.

If the Outside cut of the Oval V-Groove cuts with a Bump, Decrease the Outside Oval Rotation.

The Oval Rotation for V-Grooves controls for /wiki/spaces/FrameShop8x/pages/1942509662 or /wiki/spaces/FrameShop8x/pages/1942511032 on an Oval V-Groove.

 How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels