">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 65 Next »

Overcut on Creases

  • If the Overcut is Too Long, Decrease the Overcut.

  • If the Overcut is Too Short, Increase the Overcut.

Contents:

  • The Overcut controls where the Crease Cartridge Retracts from the Matboard.

    • If Overcut is Too Long, Decrease the Overcut.

    • If Overcut is Too Short, Increase the Overcut.

CreaseBackupOvercutEOArrows70800.png

Full Definition: Overcut Crease Definition

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 How to Adjust the Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels