Enable Auto Offset

Select Auto Offset checkbox to move the design up and over on the matboard to avoid the Clamp area on the Cut Preview.

Default Settings: See Auto Offset: Cutting Default Setting for the default settings for the Auto Offset.

Click on the design to select it.
Check the Auto Offset checkbox.
Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value.
It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.
This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.

Auto Offset Definition

The Auto Offset moves the design up and over on the Cut Preview to avoid the Clamp area.

This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.

See: Auto Offset Setting

See: Auto Offset Definition

See: Auto Offset Default Setting

Search