How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

Calculate Opening Adjustments

  1. Cut a one layer rectangle opening. 

  2. From the front of the mat, measure the Width and Height of the opening from the inside of the bevel. 

  3. Enter those values into the Actual Height and Actual Width fields. 

  4. Click on the Calc Opening Adjustment button to recalculate and adjust the Opening Adjustment value. 

  5. Do a test cut to confirm that it is correct and readjust if necessary.

  • For Additional Information:

  • See Opening Adjustment for information on adjusting the object’s size.

 Opening Adjustment General Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Opening is cut Too Large, Decrease the Opening Adjustment.

If the Opening is cut Too Small, Increase the Opening Adjustment.

See: Opening Adjustment for Openings Configurations

See: Opening Adjustment for Drops Configurations

See: Opening Adjustment for Outsides Configurations

See: Opening Adjustment for V-Grooves Configurations

See: Opening Adjustment for Deboss Configurations

See: Opening Adjustment for Pens Configurations

See: Opening Adjustment for Vinyls Configurations

See: Opening Adjustment for Creases Configurations

  • No labels