Foam Core: How to Cut Foam Core

These instructions will walk you through cutting Foam Core.

Locate the Mat Clamp Pressure Knob which is usually located on the Control Panel on the left side of the Board for CMC’s that include this feature.

The Mat Clamp Pressure Knob allows you to switch between Standard and Low Clamp Pressure.

• Pull the Mat Clamp Pressure Knob Out to use the Lower Clamp Pressure.

• Push the Mat Clamp Pressure Knob In to use the Standard Clamp Pressure.

If you are having difficulty cutting through the current Foam Core, you could further slow the cutting speed down.