Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 3
Next »
How to Place 8-Ply Matboard into the Clamps |
|---|
| |
Normally, you would place Two Layers of adequate size of disposable matboard under the Mat to be Cut. Place the matboard into the left corner of the CMC, making sure that the matboard nestles tightly into the Horizontal and Vertical Clamps.
|  |
For 8-Ply Matboard, you may need to remove one of these backing boards to make room for the thickness of the 8-Ply Matboard. This requires that you test the Blade Depth to make sure it is not too deep to avoid cutting through the one remaining backing board.
|  |