">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

How to Place 8-Ply Matboard into the Clamps

  • These instructions will show you how to place 8-Ply Matboard into the Board Clamps.

  • Normally, you would place Two Layers of adequate size of disposable matboard under the Mat to be Cut.

  • For 8-Ply Matboard, you may need to remove one of these backing boards to make room for the thickness of the 8-Ply Matboard.

  • Place the matboard into the left corner of the CMC, making sure that the matboard nestles tightly into the Horizontal and Vertical Clamps.

  • This requires that you test the Blade Depth to make sure it is not too deep to avoid cutting through the one remaining backing board.

AN9000zPlaceMatboardBack8-Ply.gif
  • No labels