">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 54 Next »

Vertical Adjustment on Non-Blade Cartridges

  • If the Non-Blade Tool line is applied Too Far Up Vertically, Decrease the Vertical Adjustment.

  • If the Non-Blade Tool line is applied Too Far Down Vertically, Increase the Vertical Adjustment.

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 How to Adjust the Vertical Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Down

  • If the Non-Blade Tool line is applied Too Far Down Vertically, Increase the Vertical Adjustment.

 Vertical Adjustment for Non-Blade Cartridges General Definition

The Vertical Adjustment defines the global Vertical placement of objects applied with the Non-Blade Tool Cartridges.

If the Non-Blade Tool line is applied Too Far Down Vertically, Increase the Vertical Adjustment.

 How to Adjust the Vertical Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Up

 Vertical Adjustment for Non-Blade Cartridges General Definition

The Vertical Adjustment defines the global Vertical placement of objects applied with the Non-Blade Tool Cartridges.

If the Non-Blade Tool line is applied Too Far Up Vertically, Decrease the Vertical Adjustment.

 How to Adjust the Vertical Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels