Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

Adjusting Blade Depth

As you use different types of matboard, it may be necessary to change the Blade Depth. Follow these steps.

1. Loosen the brass thumb-nut above the cutting Head. Flip the locking handle counter-clockwise.

2. Carefully tip the cutting Head down.

3. With the Blade Depth Adjuster set to the center position (for 4-ply), turn the Depth Adjustment Screw counter-clockwise to increase the Blade Depth, or turn it clockwise to decrease the Blade Depth.

4. Replace the cutting Head into position, flip the locking handle clockwise and tighten the thumb-nut. Make sure the Head is tight in place before cutting. Do a test cut and re-adjust as necessary.

  • No labels