This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Cutting an Extra Dense Layer with the 90 Degree Cartridge

These instructions will show how to adjust the air pressure on the head in order to cut extra dense material using the 90 Degree cartridge.

This setting is only for the 90° Cartridge and will not take affect if another cartridge is selected. This setting will allow the 90° Cartridge to cut at a slower pace.

Cutting an Extra Dense Layer with the 90 Degree Cartridge

Select the desired layer on the Cutting Preview.

Click the Blade Depth button to open the Blade Depth Screen.

Click the checkbox for Extra Dense Material and change the Blade Depth to the appropriate setting for this matboard.

Adjust the slidebar to the percentage of cutting speed. For instance, 50% is 50% of the standard cutting speed.

Click OK.

The Cutting Preview displays the Dense layer with a pound sign and indicates that this layer is Extra Dense.

Click Cut the cut the mat and Align the Head if requested.

A prompt to adjust the head pressure to the high setting displays.

Pull out the air regulator pressure knob by pulling it to the left.

Turn the air regulator pressure knob clockwise until the marker on the gauge is at the high setting.

Make sure the gauge does not go above 60 psi.

Push the air regulator pressure knob back in by pushing it to the right.

Click OK to cut the mat with this setting.

  • No labels