">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

Crease Overcut is Too Long

  • If the Overcut is Too Long, Decrease the Overcut.

🛠️ Click the Plus or Minus button several times on the desired field, do a test cut and continue adjusting until satisfied.

  • The Overcut controls where the Crease Cartridge Retracts from the Matboard.

    • If Overcut is Too Long, Decrease the Overcut.

    • If Overcut is Too Short, Increase the Overcut.

CreaseBackupOvercutEOArrows70800.png

Full Definition: Overcut Crease Definition

  • No labels